Uline H-5839 Mode D'emploi page 4

TOOL REQUIRED
M8 Flange
Nut x 2
M8 x 16 mm
Bolt x 2
M6 x 10 mm Cap Nut x 9
Screw x 9
1. Line up holes on
the bracket of
wheel assembly
with the
corresponding
holes on base,
then insert 16 mm
bolts through holes.
Hand tighten with
flange nuts. Be sure
the wheel assembly
is parallel to the
base. (See Figure 1)
Note: To improve stability, the bucket (in base)
can be filled with sand (not included).
2. Attach cylinder
housing loosely
to base with
M5 x 8 mm screws.
(See Figure 2)
PAGE 4 OF 31
Phillips Screwdriver
(not included)
M5 x 8 mm
M6 x 10 mm
Screw x 4
Bolt x 4
Wing Nut x 3
(May be attached
to head assembly)
Figure 1
Fill Sand
Figure 2
PARTS
Small Flat
Washer x 4
Stainless Steel
Bolt x 4
ASSEMBLY
3. Open the
preassembled door
on cylinder housing
and place post
through the hole
on the top.
(See Figure 3)
4. Secure post to
cylinder housing
using the reinforced
ring, M6 x 10 mm
bolts and four small
flat washers. Fasten
and cover with the
deck ring.
(See Figure 4)
Large
Reflector
Washer x 9
Spacer x 3
Wrench x 1 Reinforced
Ring x 1
Figure 3
Figure 4
Medium Flat
Washer x 9
Deck Ring x 1
0622 IH-5839