Chef'sChoice 680 Mode D'emploi page 5

Avoid spilling water on the base unit. In the event that the base unit becomes wet, proceed as follows:
– disconnect the power cord from the power outlet.
– invert base and shake out all water.
– dry the base unit with a dry absorbent cloth.
– place the kettle on the base and re-insert the power cord into the power outlet.
CautIon: The kettle always gets hot during operation. do not touch the glass body or lid. lift the kettle only by the
handle and lift the lid only by using the lid release button. Exercise care to avoid contact with steam or the water when
opening the lid while the kettle is still hot or contains hot water.
Care and Maintenance of Your Chef'sChoice
• The Chef'sChoice Kettle is designed specifically for heating water. Do not attempt to heat anything besides water
®
in the kettle. With liquids and mixtures of low water content, the automatic steam activated shut-off switch may not
function properly and the kettle may be damaged.
• Before cleaning, make sure the power switch is turned "OFF", then remove the kettle from base unit. Unplug the
base unit.
• Always wait until the kettle has fully cooled to room temperature before cleaning.
• To avoid scratching, only clean the outside of the kettle with a soft cloth.
• never use abrasive cleansers or abrasive pads on either the inside or outside glass surface of this product.
• The interior of the kettle can be cleaned by decalcification at regular intervals (see next page).
• Rinse out kettle at regular intervals and after extended non-use. Do not immerse.
• Do not attempt to clean any part of the kettle or base in the dishwasher.
Kettle
®
5