Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• A short power supply cord is provided with this appliance to reduce the risk of someone becoming entangled in or
tripping over a longer cord and causing the Kettle to overturn, discharging its hot contents. While EdgeCraft does
not recommend it, extension cords are available and may be used if care is exercised in their use. if an extension
cord is used, it should be a grounded three conductor cord rated at not less than 15 amperes and match the
configuration of the plug. The longer cord should be arranged so that it will not drape over the counter top or
tabletop where it can be pulled on or tipped over by children or the infirm.
• Plug base unit into a three way grounded 110-120 volt, AC outlet.
• The kettle power switch (5) has two positions: "ON" (|) and "OFF" (0). Place the kettle on it's base and push the
switch down to the "ON" position. The switch will illuminate to indicate the power is on.
• The kettle, if filled to the "maximum level" normally switches "OFF" automatically within approximately 30 seconds
after the boiling point is reached.
• The time required for the kettle to automatically switch "OFF" after the boiling point is reached will vary depending
on the amount of water in the kettle. it will switch off faster after boiling if filled to its "maximum" level than if filled
to only a minimum level.
• If only warm water is desired, simply
interrupt the heating procedure at any
time but always first lift the power switch
(5) to "OFF" (0) before lifting the kettle.
• The kettle can be lifted easily from the
base for pouring or serving. The pouring
spout has been specially designed to
easily pour even small amounts of water.
• Replace the kettle on the base unit when
finished pouring.
• The power switch must be pushed to the
"ON" position again if you wish to restart
the heating of the water. Always check
the water level before turning the power
switch "ON". make certain there are at
least 16 ounces (0.5 liters) of water in
kettle before turning switch "ON". Avoid
boiling the kettle dry.
10
7
8
9
4
figure 1.
4
1
2
6
3
5
1. lid
2. lid Release Button
3. Water level Gauge
4. Base Unit
5. illuminated Power Switch
Pull up to power "OFF"
Push down to power "ON"
6. Handle
7. Spout
8. Stainless Steel Body
9. 360° Power Connector
10. Filter Screen
Publicité
Table des Matières
