flamco Rossweiner Smart Node 2 Instructions De Montage page 8

2.2. Commissioning Smart Node without power supply unit
Opening the housing
1
Unscrew the four screws on the cover to open the cover.
Mounting the device
2
The housing has four slotted holes for oval-head screws.
For mounting on walls, we recommend screws with a diameter of 5 mm and a length of at
least 25 mm and matching rawl plugs, as well as washers with an external diameter of 10 mm.
Inserting the SIM card
3
This step is optional because all of our devices are delivered with a SIM card.
It is possible to replace this with your own card at any time.
Set the mains switch to "on"
4
Switching the power switch to "on" activates the device and it goes into installation mode.
This remains active for 30 minutes and can be extended by a control command or by
switching the magnetic switch on the board (using a magnet).
Caution: This is at the expense of battery life.
Server connection
5
After switching on, the gateway connects to the server via the network (GSM). The connection
process usually takes no more than 90 seconds.
Closing the housing
6
Close the housing using the four screws and seal it with the optional front foil.
[4] Mains switch [4.1] Magnetic switch [3] SIM
8
Smart Node 2
[2] Slotted holes