Orbegozo SV 2600 Manuel D'instructions page 12

SV 2600
SPRAYING
Press the spraying button, steam will be sprayed out from the spraying nozzle. At
that time, you should keep enough water in the water tank.
STEAM IRONING
1. Use steam ironing, turn the steam control to minimum position and set the
temperature control at the ".", ".." or "..." position.
2. After the indicator goes out, turn the steam control to the suitable position,
steam will be sprayed, ironing can start.
BURSTING STEAM
Set the temperature control at the "..." position, then press down the bursting
steam button, the base plate will spray out bursting steam.
DRY IRONING
Turn the steam control to minimum position, set the temperature control to the
suitable position, you can dry ironing.
SELF CLEANING
Set the temperature control to the maximum position, press the self clean button
for about 1 minter, strong steam will be sprayed to clean the steam chamber. Use the
function once every two weeks.
ANTI-DRIP:
This iron is equipped with a drip stop function: the iron automatically stops steaming
when the temperature is too low to prevent water from dripping out of the soleplate.
ANTI-CALC:
The Anti-calc function filtrate the minerals from the water to prevent mineral
residue build up at the steam chamber.
AUTOMATIC SHUT OFF
The iron is switched on and not moved for a period of 8 minutes while standing on
its heel or 30 seconds while standing on the soleplate, an internal safety feature will
switch the iron off and the auto-shutoff indicator will blink. Move the appliance sharply
to switch it on again.
STORAGE
After using, pull out the plug, pour out the remaining water, turn the steam control
to minimum, turn the temperature control to "min", let the iron cool down, put the iron
on the safe and dry place vertically.
12