Emptying Your Floormate Cordless Dirty Water Tank - Hoover FLOORMATE BH55100PC Guide D'utilisation

Emptying your FloorMate
WARNING
To reduce the risk of personal injury -
! !
Remove battery pack before cleaning or servicing.
LEFT
FRONT
1
Press this button and
pivot the tank out.
NOTE:
An automatic suction shut-off is built into the dirty water tank
to prevent overflowing. When the shut-off activates, the cleaner will
not pick up water or debris and the motor sound will change. The
dirty water tank is full and must be emptied.
See us do it:
hooverhelp.com/FloorMateCordless22
® Cordless dirty water tank and filter

2 3
Release these tabs
and pull the tank lid
up to remove.
CAUTION
Water will drip from the brushes and underside of the
! !
product after use and may puddle. To avoid damage to wood and laminate
flooring and to avoid potential slip hazard,after use (a) do not leave the product
on wood and laminate surfaces and remove to a hard surface and (b) place unit
on absorbent material(such as a towel) to soak up drips.
4
Empty water into Replace the tank lid
sink or toilet. Check and latch both tabs into
foam filter for debris the locked position.
and rinse as needed.
LEFT
FRONT
5
Snap the tank
back into its
original position.
8