Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.10 START PROGRAMMED FUNCTIONS
→
→
6.11 CHANGE DISPLAY LANGUAGE (english)
→
→
.
selected
7 USB CONNECTION
Preparation of communication :
Download on our website
Connect the power supply to the USB2.0 PC port with a USB cable
as A / B type USB (its length shouldn't exceed 5 meters).
Install the file.
Your PC is ready to communicate with the ALR3203.
Use "Hyper Terminal ®" simple utility to communicate via the serial port, present on all
PCs with Windows 95®, 98®, XP®, Seven®.
You will find on the website www.elc.fr, LabVIEW ® drivers and user manual.
The USB connection allows to upgrade the Firmware (see website).
8 MAINTENANCE
No particular maintenance is required for this instrument.
Avoid : dust, humidity, shocks ; your instrument will appreciate it.
For the cleaning, please use a smooth duster.
8.1
TROUBLESHOOTING
If indicators do not light up on switching on, check :
- The connection to mains
- The replacement of the cord can be realized only with the model :
2
3G 0.75mm
; H05VV-F; CEE7/7 - IEC60320 C13
- The mains voltage
- That the ON/OFF switch is pressed
8.2
ERROR MESSAGE
If following messages appear on the display, please contact the after sales service.
Message
"FAULT : FAILURE START-UP VOLTAGE"
"UNREGULATED CURRENT/VOLTAGE
PROTECTION"
9 AFTER SALES SERVICE
The after sales service is ensured by the elc company.
During two years, spare parts and workmanship are guaranteed. This guarantee does not
apply to instruments presenting defects or faults caused by an improper use (wrong mains
voltage, shocks ...) or which have been repaired outside our factory or the repair shops of our
authorized agencies.
4000 4 362-10-20
Follow and valid choices with key
→
→
→
→
the file : ALR32xx.inf
www.elc.fr
Possible cause
Internal auxiliary power doesn't work
Internal stage power doesn't work
20
English language
ENGLISH
Publicité
Table des Matières
