2.3
SAFETY INSTRUCTIONS
Before any operation, read the following safety precautions to avoid injury and prevent
damage to this product or another connected.
To avoid all potential hazards, use this product only in the specified limits.
o
Do not use the device without its cover. Do not use the item with its
o
housing or any panels removed.
o Any intervention inside the casing, and particularly the fuses replacement, must
imperatively be effected by a skilled staff.
o The instrument must be used according to the instructions of this manual.
o Use it in a well ventilated area. The air inlets must be widely free, do not block
them.
o Do not use in wet conditions. Do not use in wet environment to avoid electric
shocks or short-circuit inside the product.
o Do not use in an explosive atmosphere. It is very important do not operate the
item near an explosive atmosphere, to prevent damage to the device or any
personal injuries.
o The power cable is used as a cut system, the product must be connected to a
230V main source, easily accessible, with earth.
o When this unit must be powered via a separate autotransformer for a reduction
of voltage, ensure that the common socket is connected to the grounding pole of
the circuit of the supply.
The common mode voltage between ground and the output terminals
o
must not exceed 150VDC. In this case a deemed dangerous voltage (> 60VDC)
can be reached between one of the terminals and earth. Therefore, it is
imperative to use safety cables to connect the outputs of the device. Also, all
connected devices must not have conductive parts accessible.
2.4
SAFETY TERMS AND SYMBOLS
You will find the following symbols on this equipment :
CAUTION REFER
TO MANUEL
2.5
PACKAGING AND REPACKAGING
Your power supply ALR3203 comes with an quick start guide and its power cable 2 poles + earth type
"EUROPE" : CEE7 / 7 - IEC60320 C13.
User manual is available in our website : www.elc.fr
4000 4 362-10-20
CAUTION HIGH VOLTAGE
RISK
14
PROTECTIVE GROUND
(EARTH) TERMINAL
ENGLISH