GORMAN-RUPP Fill-Rite FR300V Serie Manuel D'installation Et D'utilisation page 4

Pompe de transfert de carburant
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

|
CAUTION
Threaded pipe joints and connections should be sealed with the appropriate sealant or sealant tape to minimize the possibility of leaks.
Typical Skid Tank Installation
Materials
1-1/4" pipe cut to a length that will terminate at least 3" from the bottom of the
tank when installed into the tank adapter with the tank adapter installed into
the tank flange (see SKID TANK INSTALLATION diagram).
Threaded pipe joint sealant appropriate for application.
Installation Procedure
1.
Thread the 1-1/4" pipe into the tank adapter. Seal threads liquid tight with
appropriate thread sealant.
2.
Screw the tank adapter into the tank flange; seal threads liquid tight with
appropriate thread sealant.
3.
Mount the pump on the adapter; seal threads liquid tight with appropriate
thread sealant.
4.
Fill-Rite recommends installation of an Anti-Siphon Device.
Typical "Pedestal / Island" Installation
Materials
1-1/4" threaded suction pipe, cut to extend 32-1/2" above the island.
FRPA125 Pedestal Kit (includes Pedestal Pipe, Base, & Coupler).
Threaded pipe joint sealant appropriate for application.
Installation Procedure
1.
Remove the coupler from the pedestal pipe by loosening the set screws.
2.
Slip the pedestal pipe/pump base assembly over the 1-1/4" suction pipe.
3.
Loosen the screws in the pedestal base to allow the pedestal pipe to slide down
exposing the end of the suction pipe.
4.
Screw the coupler onto the suction pipe; seal threads liquid tight with
appropriate thread sealant.
5.
Slide the pedestal pipe into the coupler and tighten the set screws.
6.
Tighten the screws in the pedestal base.
7.
Mount the pump on the coupler seal threads liquid tight with appropriate
thread sealant.
LAYOUT OF BASE ANCHOR BOLTS
1/2" BOLTS
1-7/8"
ELECTRICAL CONDUIT
CLEARANCE HOLE
7-25/32"
1-7/8"
PUMP FRONT
fillrite.com
FR300V SERIES FUEL TRANSFER PUMPS
INSTALLATION AND OPERATION MANUAL
SKID TANK INSTALLATION
TYPICAL PEDESTAL / ISLAND INSTALLATION
PEDESTAL COUPLER
PEDESTAL PIPE
PEDESTAL BASE
FUEL TANK
1-1/4" SUCTION PIPE
TANK ADAPTOR
SKID TANK
Additional
specifications on page 7.
Additional specifications
on page 7.
ELECTRICAL CONDUIT
CONCRETE ISLAND
36" SQUARE
3" MIN. OFF
TANK BOTTOM
4

Publicité

Table des Matières
loading

Produits Connexes pour GORMAN-RUPP Fill-Rite FR300V Serie

Ce manuel est également adapté pour:

Fill-rite fr310vFill-rite fr311vFill-rite fr319v

Table des Matières