Publicité
MALONE
8 height settings (56" - 63")
LoadRoller
with
tm
mounting hardware (1)
10 width settings (32"- 48")
Side arm load containment
The LoadRoller
1
● With your Axis
assembled and installed, remove the locking pin from one of the wings/end posts and slide
tm
the wing outwards.
● Make sure the mounting bolts and washers are removed and insert the LoadRoller
end posts lower mounting hole.
Dimensions: 63x48"
. Insert Mounting Bolt through one hole of a Jawz adapter.
Insert washer and loosely apply a T-knob. See image 2.
. Faites passer le boulon de fixation dans l'un des trous
d'un adaptateur Jawz puis vissez légèrement un bouton
en ''T'' à la base du boulon. (Figure 2)
3
● Reinstall the other wing/end post, aligning the LoadRoller
needed to center the LoadRoller
● Secure the roller to the wings/end posts with the washers and lock nuts on each side. Be careful not to
over-tighten as the roller should move freely.
R
Axis
MALONE
LoadRoller
Load Extender
TRUCK BED EXTENDER ROLLER
DownLoader
DownLoader
Features Include:
Kayak Carriers
Load Straps
Installation & Loading Instructions - Please Read Before Beginning
Veuillez lire les instructions avant d'entreprendre l'installation et le chargement
tm
attaches to the Axis
2" receiver wtih pin
Powder coat finish
Base Pad
Capacity: 500 lbs
Weight: 33 lbs
Lifetime warranty
tm
and insert the locking pin for the wing/end post.
J-STYLE FOLDING KAYAK CARRIER
60mm
Jawz Universal Adapters
Mounting Bolts
tm
and makes loading easier and safer.
. Prior to installation, insert a bolt into the mounting holes in
the bottom of the carriers. Push upward to open the two
mounting hole covers located in the Base pads.
. Insert a Mounting Bolt into one mounting hole from the top
side. Rotate and close the mounting hole cover.
See image 1.
. Insérez un boulon de fixation dans l'un des trous hexagonaux
situés sur le côté supérieur du support.
(Figure 1)
Covers
2
. Place the carrier onto the front cross bar with the boarding
ramp facing out. Swing the Jawz under the cross bar as
shown. See image 3.
. Placez le support sur la barre transversale avant, la rampe
de chargement vers l'extérieur. Faites passer l'adaptateur
Jawz sous la barre transversale, tel qu'indiqué. (Figure 3)
tm
with the lower hole in the wing/end post. Adjust as
TM
R
TM
Mounting Bolt Washers
70mm
T-Knobs
12' Safety Lines
tm
MPG909
into the attached wing/
1
Publicité
