Best UP27M Serie Instructions D'installation page 10

15. REINSTALL THE PAN
Insert the front of the pan inside the hood (), while its front rests on inner front of hood, start mounting the pan by the back retaining
screws () (2 or 4 according to hood width), then, screw the front of the pan to the hood using remaining screws (previously removed in
step 5).
HD0117
16. REINSTALL HYBRID BAFFLE FILTERS
Remove protective plastic film covering hybrid baffle filters before installing them.
It is recommended to install side filters first and finish with center
one.
 Insert the end with filter spring clip of hybrid baffle filter into the
front channel of the hood.
 Raise the other end toward the inside of hood and insert in the
grease drip rail of the hood.
Replacement filters are available from your dealer. See label inside
hood for size and part number.
17. LIGHT BULBS REPLACEMENT
This hood requires 120 V, 50 W, MR16 or PAR16 with GU10 base, shielded halogen lamps (included).
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a cool beam, a dichroïc lamp, a lamp not suitable for use in
recessed luminaires or identified for use in enclosed fixtures.
1. To remove lamps, gently push upwards and turn counterclockwise to
disengage bulb leads from their grooves.
2. Install the new lamps by placing the bulb leads into their grooves in
the socket.
3. Gently push upwards and turn clockwise until secure.
NOTE: To ease removal of the bulbs, use a rubber dishwashing
glove or use suction cup tool available from Best. Contact
Best Technical Support at 1-800-558-1711 to order suction
cup tool, part no. 99526707.
CAUTION
HD0550
WARNING
!
1
HO0089
10
2 3