Signature Design by Ashley 2160412 Instructions De Montage page 5

7. Plug the Lumbar and Headrest, See the Figure D. If your model is Headrest Only, you only need to plug the Headrest.
Figure E
Lumbar
Lumbar
Lumbar
Lumbar
Headrest
Headrest Headrest
Headrest
8. Connect the Power Transformer cable to the corresponding plug coming from the back of the chair Figure A #4
9. Connect the Power Cord into the Power Transformer Figure A #5
10. Connect the power cord into an electrical outlet near where the chair will be used Figure A #6
WARNING: Clear area below chair before operating to reduce risk of injury or death.
The power button is intended to allow you to disable the chair functions.
To stop the chair from functioning using the power button, press the Power Button until the LED light is off.
If the chair is not functioning, check the plug in and connection of the cords first (The order is A-B-C-D), see Figure A
If all connections are good, verify the LED is lit on the power button. See illustration on bottom of page Figure A-Power Button
Be sure cords are clear from the chair prior to operation.
FLOOR GLIDES
Your Ashley Power Chair has four adjustable floor glides. These glides can be adjusted to level your chair on uneven flooring. Remove these floor
glides may result in damage to your chair and flooring.
TROUBLE SHOOTING
-PROBLEM
Chair will not operate
-POSSIBLE FACTORS
Transformer may not be connected
-SOLUTIONS
Ensure both wire from the chair and the power cord is firmly connected to the transformer
Figure F
OPTIONAL
LITHIUM BATTERY PACK:
By adding the lithium battery pack to the power transformer, it enhances your existing power transformer with battery back-up feature.
If you wish to purchase the lithium battery pack, please contact us at 1 -844-696-6886.
SIGNATURE DESIGN BY ASHLEY ® All Rights Reserved. December, 2017 00172A Page 5 of 26