Signature Design by Ashley 2160412 Instructions De Montage page 3

COVER MATERIAL CARE INSTRUCTIONS
The material covering this piece of furniture is very durable for everyday living. It is recommended by the manufacturer to only clean
this material with water-based cleaning agents or soap. Lightly scrubbing will help with any tougher spots that may have developed.
Always check a small spot of material in an area that is unseen to be sure the cleaning agent being used will not discolor or fade the
material's finishing. Let the chair air dry and vacuum for the best result.
CHAIR ASSEMBLY - CORD AND POWER TRANSFORMER CONNECTIONS
WARNING: It is important that you read and carefully follow all chair assembly instructions. Do not plug the power cord into
an electrical outlet until all assembly has been properly completed. Failure to follow all chair assembly instructions may cause the
chair to operate improperly possibly resulting in the risk of personal injury or death.
CHAIR ASSEMBLY
Once the chair is removed from the box, you'll notice the back is lying on the top of the seat. There are couple of items to remove
from the seat portion of the chair first. Follow below instructions:
1. Some models have back wings which are attached, when unpacking your chair you will find these back wings packed in the back
of the chair base, Figure A #1 Please unpack the back wings and set them aside for installation later.
2. Locate the hardware pack that contains the power transformer, power cord and the control wand. This can be done by turning the
base over on its arms, you will see the plastic bag tied to the inside of the unit, Carefully cut the ties that hold the bag and remove it.
Dispose of the ties and bag properly. Figure A #2
3. If your chair uses a control wand. Remove the control wand from the plastic bag and connect it to the female plug located in the
left side pocket of the chair, Figure A #3
Figure A
The Power Button is designed to disable the power operation. It is in the cable that connects the motor to the
transformer. It is a press button. When the button is pressed to the off position, the Green Light on the Power button is
not lit. When the button is in the ON position, the Green Light in the Power Button will lit and the unit will operate.
This Class B digital device complies with part 15 of FCC rules. "Operation is subject to following two conditions: (1) this d evice may not
cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation. T o
comply with the FCC RF exposure requirements, no change to the antenna or device is permitted Any change to the antenna or device could
result in the device exceeding the RF exposure requirement and void users right to operate device.
SIGNATURE DESIGN BY ASHLEY ® All Rights Reserved. December, 2017 00172A Page 3 of 26