CRC SmartWasher SW-23-RGB Manuel D'instructions page 31

ISSUE REMEDIAL ACTION
Cold fluid If the SmartWasher is low on fluid, the heater automatically shuts off
- Check to see if the "Add Fluid" indicators are lit. There should be approximately 28 cm of
fluid in the machine when it is low
- If the"Add Fluid" light is illuminated, add a full container (20 litres) of OzzyJuice
indicator light should go out.
- Allow for a reasonable warm up period and then recheck.
Overheated If the fluid becomes extremely hot and exceeds 49°C, unplug the SmartWasher
fluid your local CRC distributor.
Spilled - OzzyJuice
spilled fluid.
OzzyJuice
®
- To clean up an accidental spill of new, unused fluid simply soak up the solution with an
absorbent material, (or wash spillage down the nearest sanitary sewer).
- If the spilled OzzyJuice
with local regulations.
- If left to dry, the fluid will leave a tacky spot on the floor that when wet, will again
become slippery.
Excessive oil - Unplug the SmartWasher
- Skim excessive oil off the top of the OzzyJuice
dumped in
fluid, soak up the oil and dispose of it in accordance with local regulations.
system
- In extreme cases, it may be necessary to replace all of the OzzyJuice
SmartWasher
regulations.
- If you replace all of the OzzyJuice
excess oil and dirt.
- Once unit has been cleaned, re-install the sink (without the false bottom and OzzyMat
and add 60 or 95 liter of new OzzyJuice
- Re-install the false bottom with a new OzzyMat
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
11. Troubleshooting
will cause the floor to become slippery. Use caution when walking in or near
®
has been used, you must dispose of the spillage in accordance
®
and lift the sink off the base.
®
. Dispose of contaminated OzzyJuice
®
ORIGINAL INSTRUCTIONS
or place an absorbent pad on top of the
®
and OzzyMat
®
, rinse the base of the SmartWasher to remove all
®
(depending on the SmartWasher
®
.
®
®
. The
®
and contact
®
in the
®
accordance to local
®
,
®
type).
®
page 31 of 640