Grundig GDS 2460 B Manuel D'utilisation page 14

5 Installation of appliance
(Figure 4)
Hold the cooker hood by its body and place it on
the suspension screws on the wall and tighten the
screws (Figure 4).
Fix the cooker hood with 4.8x50 screws through
the mounting hole on the interior of the appliance
(Figure 4).
5.4 Connecting to flue
If you are going to use the Ø 120/150 mm plastic
flue adapter, connect one end of the pipe to this
adapter, if you are not going to use it, to the direct
output on the product. Connect the other end of
the pipe to your flue. Check that these two con-
nections are tight enough so they will not come out
when the appliance runs on full power. Ensure that
the flaps inside the flue work when tightened with
clamp. Connect the flue connection duct outside
the adapter. If the connection duct is fitted inside
the adapter, the covers that prevent air return shall
remain closed and air won't be sucked in. The
length of the pipe connection as well as the num-
ber of elbows must be as minimum as possible.
A : Flue exit pipe
B : Non return flaps
C: Plastic Flue
14 / EN
The covers are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
(a)
Ok
5.5 Mounting the flue
Make the electrical connection of your product be-
fore starting flue installation. Insert the flue plates
Around the body. Screw the Outer chimney to the
Outer chimney fastening plates which are on the
motor cabin (Figure 5). Extend the Inner chimney
to the flue fastening plate fixed to the wall from its
upper outer edge, and screw.
(Figure 5)
1. Inner chimney
2. Inner chimney Connection Screws
3. Flue Connection Plate
4. Outer chimney Connection Screws
Cooker Hood / User Manual
(b)
Not Ok