Publicité
Les langues disponibles
Les langues disponibles
STEP A
1-
Remove bolt #BB, cutter pin #CC , washers #DD and nut
2-
Remove ski #AA from spindle #HH.
STEP E
7-
Drill hole thru shoulder of ski #AA with 1/4"drill bit, using the
hole on the base #1 as a guide. (THE BASE SOULD BE
PARALLEL TO THE SKI).
Clean drilled hole of any debris.
8-
SIDE VIEW
STEP B
3-
Remove bushing #EE from ski #AA. (The one on the same side
where the ROLLERSKI wil be installed.)
STEP F
Insert bolt #6 into the base #1 et le ski #AA.
9-
10-
Thigten nut #5 on bolt #6
Insert ski stopper #FF** into ski #AA
11-
STEP C
4-
Remove bolts #3 and #6,nuts #4 and #5, socket #2 and shim
#7 from base #1 of ROLLERSKI.
STEP G
Lightly grease bolt #3.
12-
13-
Insert bolt #3 into base #1 of ROLLERSKI, ski #AA, spacer
#JJ,spindle #HH**and spacer #JJ.
14-
Thigten nut #4 on bolts #3 as per the same manufacturer's
specifications of bolt #BB.
STEP D
5-
Insert socket #2* of ROLLERSKI into ski where the bushing was
removed.
6-
Tighten socket #2 thru shim #2 and base #1 of ROLLERSKI. (THE
BASE SOULD BE PARALLEL TO THE SKI).
*
THE SOCKET (#2) WILL REPLACES THE BUSHING
REMOVED AT STEP B.
THE SPINDLE (#HH) SPACER (#JJ) AND SKI STOPPER
**
(#FF) ARE NOT SHOWN FOR MORE CLARITY.
THE ROLLERSKI MUST BE INSTALLED ON THE INSIDE
OF SKI.
THE ROLLERSKI, WHEN NOT ENGAGED, MUST BE
POINTING FORWARD.
MAXIMUM SPEED WHEN ROLLERSKI ARE ENGAGED IS
20KM/H (12 mph).
ARCTIC CAT PARTS
QUALIPIÈCES PARTS
2017-12-12
REV: A
Publicité
