Publicité
Fixing the ornamental chimney
* Before fixing the chimney, place the electric feeding
equipment into the ornamental pipe and provide a hole for the
air outlet if the appliance is used in its sucking version.
Warning!
Before connecting the flexible exhausting pipe to the motor,
make sure the stop valve, which is on the air outlet of the
motor, can swing.
Sucking version
* Fix the pipe-bearing stirrup (Fig.7Y) to the wall or ceiling by
using the proper reinforcements and screws in equipment.
Connect the range hood flange with the evacuation hole by
using a proper pipe. Perform the electrical connections. The
superior end of the pipe is to be fixed laterally to the pipe
bearing (Fig.8Y) by using the two self-threading screws. Now
mount the inferior chimney by inserting it through the front
side of the range hood and then turning it down until it is fixed
inside (Fig.8).
Filtering version
* In the filtering version the air deviator is fixed through the
screws supplied (Fig.9), by using the holes which are on the
back of the upper telescopic section. Connect the flange of the
appliance with the air deviator through an appropriate pipe.
Connect the appliance with the electric mains.
WORKING
Mod. 5CFB-48X – 5CFB-36X – 5CFB-30X - Module -
Luxury version (Fig. 10)
A: Light switch on/off
B: Motor switch on/off (1st rate level)
nd
C: 2
rate level switch
rd
D: 3
rate level switch
th
E: 4
rate level switch
F: 10-minute timer.
MAINTENANCE
* An accurate maintenance guarantees good functioning and
long-lasting performance.
* Particular care is due to the grease filter panel. It can be
removed by pushing its special handle toward the back-side of
the range hood and turning the filter downwards so as to
unfasten it from its slot (Fig.3B). To insert the filter just
perform the opposite operation. After 30 hours of operation,
the push button control panel will signal the saturation of the
All manuals and user guides at all-guides.com
5
grease filter by lighting all the buttons. Press the timer button
to reset
. The grease filter should be cleaned by hand or in
dishwashers at least every two months or depending on its
use.
* In case the appliance is used in its filtering version, the
active coal filter (Fig.11) needs to be periodically replaced.
The coal filter can be removed by removing the grease filter
first (Fig.11B), and by pulling its special plastic tongue until it
is unfastened from its slot. Re-insert the coal filter by reversing
the steps. The coal filter needs replacing at least every six
months, depending on the use.
* To clean the appliance itself, tepid water and neutral
detergent are recommended, while abrasive products should
be avoided. For steel appliances specialized detergents are
recommended (please follow the instructions indicated on the
product itself to obtain the desired results).
* Before replacing the lamps, disconnect the appliance from
the electric mains. Remove the grease filter and the carbon
filter, if it is inserted (Fig.8). Once the burnt out bulb is located,
turn it counter-clockwise and replace it with a bulb of the same
type.
* To replace the halogen lamps, remove first the glass
blocking ring (Fig.13A), by levering with a screw-driver and
thus removing the opaque glass (Fig.13B) - when performing
this operation hold the opaque glass carefully. Remove the
lamp (Fig.13C) without touching it with uncovered hands.
Replace it with another lamp of the same kind. After the
replacement, re-insert the glass blocking ring and fasten it.
Publicité
