Quick Start Guide; User Operations - GBC WIRE BINDER G1 Manuel D'instructions Et D'utilisation

5. BINDER G1 DIES
Prior to Operation of the BINDER G1, a BINDER G1 die set must
be installed into the PUNCH G2. BINDER G1 will not function
unless one of the die sets listed below is installed.
Die Set Details
A die set from the following list must be used. Refer to Section 10 of
this document for further details.
Die, eWire, 3:1, Round
Die, eWire, 3:1, Square
Punched Hole Quality
Prior to operating the BINDER G1 for the first time, or whenever a die
set is changed, perform the hole quality check outlined in Section 9 B.

6. QUICK START GUIDE

BINDER G1 must be connected to AC power and the rear ON/OFF
switch should be ON to enable any feature of the machine.
 A spool of the correct size twin loop wire must be installed
before running a bind job. See Section 7 B for details on
loading twin loop spools into the BINDER G1
 Ensure that the book drawer in area 4 is set to the size paper
you intend to use, shown below.
 If running A5 or Statement size jobs, install the book drawer
bar. To install the book drawer bar, place the drawer guides
in the narrowest postion and then slide the bar underneath
the guides until the indicators touch the edge, shown below.
 Check that the PUNCH G2 has a BINDER G1 die as detailed
in Section 5.
7714915
7714916
6
WIRE BINDER G1
 Do not open doors while the machine is operating. The
current job will not resume if any BINDER G1 doors are
opened while "RUNNING BINDING" OR "PAUSED" is
displayed on the LCD.
When binding is not directed the machine will operate in bypass mode.
DOWN
Layout of BINDER G1 LCD User Interface

7. USER OPERATIONS

A. Removing Supply Spool from the Machine:
Supply spools can be removed from the machine before they are
empty to be stored for future use.
B. Installing a New Supply Spool into the Machine:
BINDER G1 offers a variety of different twin loop wire options,
depending on the requirements of your job. Load a new wire
supply spool if a different size or color of binding is required, or
when the spool is empty.
C. Supply Spool Storage:
The twin loop wire supply spools should always be stored
according to the guidelines listed to prevent damage.
D. Emptying the Book Drawer:
Empty the book drawer to remove your bound books.
E. Clearing Jams:
How to clear paper or wire jams.
GB
UP
OK