Chapter 1: Connections & Setup; Things To Consider Before You Connect; Protect Against Power Surges; Protect Components From Overheating - RCA TOCOM 1616332A Manuel D'utilisation

www.DataSheet4U.com
www.DataSheet4U.com

Things to Consider Before You Connect

Protect Against Power Surges

• Connect all components before you plug any of their power cords into the wall outlet.
• Turn off the TV and/or component before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions
packed separately.

Protect Components from Overheating

• Don't block ventilation holes on any of the components. Arrange the components so that air can circulate
freely.
• Don't stack components.
• If you place components in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't flow
around other components.

Position Cables Properly to Avoid Audio Interference

• Insert each cable firmly into the designated jack.
• If you place components above the TV, route all cables down the side of the back of the TV instead of
straight down the middle of the TV.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables
away from audio/video cables.

Important Stand and Base Safety Information

Choose the location for your TV carefully. Place the TV on a stand or base that is of adequate size and strength
to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal
injury and/or damage the TV. Refer to the Important Safety Instructions packed separately.

Use Indirect Light

Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect
lighting.

Cables Needed to Connect Components to Your TV

The pictures below show the cables needed for the connections represented in this book.
Coaxial cable
Chapter 1
Graphics contained within this publication are for representation only.
Chapter 1: Connections & Setup
S-Video cable Audio/Video cables
3