Heath Zenith 5942 Mode D'emploi page 7

SYMPTOM
The lights stay on
continuously.
The lights flash on and off.
The lights flash once then
stay off in manual mode.
206619-03
POSSIBLE CAUSE
1. The motion sensor may be picking up a heat
source like an air vent, dryer vent, or brightly
painted, heat-reflective surface.
2. The motion sensor is in manual mode.
3. The light fixture is wired through a dimmer
or timer.
4. The light fixture is on the same circuit as a
motor, transformer, or fluorescent bulb.
1. Heat or light from the lamp heads may be
turning the motion sensor on and off.
2. Heat is being reflected from other objects
and may be turning the motion sensor on
and off.
3. The motion sensor is in "TEST" mode and
warming up.
The motion sensor is detecting light from the
lamp heads.
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
SOLUTION
1. Decrease the "SENS" setting or reposition
the motion sensor.
2. Set ON-TIME switch to 1, 5, or 20 minutes.
Follow Manual Mode instructions on page 5
to reset.
3. Do not use a dimmer or timer to control the
light fixture. Replace the dimmer or timer
with a standard on/off wall switch.
4. Install the light fixture on a circuit without
motors, transformers, or fluorescent bulbs.
1. Reposition the lamp heads away from the
motion sensor.
2. Decrease the "SENS" setting or reposition
the motion sensor.
3. While in TEST mode, the light only stays on
for 8 seconds. Set ON-TIME switch to 1, 5,
or 20 minutes.
Reposition the lamp heads to keep the area below
the motion sensor relatively dark.
7