Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Maintenance
Assuming that the PlasmaMade Airfilter has been installed according to the instructions,
it requires little maintenance. The PlasmaMade Airfilter is cleaned automatically as soon
as it is put into operation.
If the outside or the sensor becomes dirty with for example dust deposits, these may be
cleaned off simply using a vacuum cleaner.
There are no components that need to be replaced periodically.
You must follow the maintenance instructions of your extractor hood.
The grease filters must be of a good quality, always cleaned regularly and in order to
prevent contamination of the PlasmaMade filter.
7. Faults
Incompetent repairs are dangerous – you run the risk of an electric
shock! If the device is faulty, remove the plug from the socket and contact
customer service.
service@plasmamade.com
Fault
Possible cause
Device does not
The plug is not inserted
work.
in the socket.
Power cut.
Blown fuse.
Red lamp flashing. Overloading of filter.
Blue light slashes The cleaning time of
during the
the filter is reaches.
operating mode.
Blue lamp
The maximum lifetime of Purchase a new filter.
flashing.
the filter is reached.
If the error is not resolved after these operations, please refer to our Helpdesk at:
www.plasmamadeservice.com
Solution
Put the plug into the wall socket.
Check whether other kitchen equipment is
working.
Check in the meter cupboard whether the
device's fuse is intact.
Remove power from the filter temporarily
(remove the plug from the socket briefly) –
thereafter the electronics will reset itself.
Turn the hood off. You can re-enable
the hood after 1-2 minutes.
20
Publicité
Table des Matières
