Wiring Diagram - Pinnacle International Remington HH-45-KFA Manuel De L'utilisateur Et Instructions D'utilisation

PUMP PRESSURE:
While heater is operating, turn adjusting screw
clockwise to increase, counter-clockwise to
decrease pressure. Correct pump pressure is as
follows:
Model Number
HH-45-KFA
HH-75T-KFA
HH-135T-KFA
HH-190T-KFA
HH-215T-KFA
Tolerance ± 10%
Pressure Valve
Adjusting Screw
Figure 18
75T / 135T / 190T / 215T-KFA With Optional Power Outlet
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
Maintenance
Pump Pressure
3.0 PSI
4.2PSI
5.5 PSI
8.5 PSI
9.0 PSI
Wiring Diagrams
45-KFA Without Optional Power Outlet
11
NOZZLES:
Nozzles should be cleaned or replaced at least
once per heating season. Contaminated fuel could
make this necessary immediately. To clean dirt
from nozzle, blow compressed air through nozzle
front. It may be necessary to soak the nozzle in
1-K kerosene to loosen any dirt particles.
Nozzle Face
75T / 135T / 190T / 215T-KFA Without Optional Power Outlet
Kerosene Forced Air Heater User's Manual
Nozzle
Burner Head
Figure 19