Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
it en
function for the first time, do not direct the steam
jet on the garments because manufacturing
residues may be present in the steam dispenser.
Never add any perfume, vinegar, starch,
scale-removing agents, ironing products or
other chemicals in the water reservoir - unless
recommended by Hotpoint-Ariston. Never use
contaminated water or coming from driers,
accumulators or air conditioners.
FILLING THE WATER
RESERVOIR
Water plays an essential role both in the ironing
process and in the good operation of the appliance
over a long lifespan. In particular, a high concentration
of limescale may damage some parts of the iron and
cause its early deterioration.
The iron water tank has a capacity of 1200ml with
extra 200ml boiler.
Suitable water
Although the iron with steam generator can be used
with tap water, if the water is very hard (as measured
in French degrees), we recommend mixing tap water
and demineralised water according to the following
table.
Hardness
degree [°f]
[tap water:demineralised water]
7°f
7°f - 14°f
14°f - 22°f
22°f - 32°f
32°f - 54°f
>54°f
To determine the hardness degree of the water in
your area, contact your local water board or body.
This data is sometimes available on the board/body's
website too.
Filling the water reservoir (A)
Before every use and every time the no-water
indicator light turns on, fill the water reservoir:
1.
Use the special handle to remove the water
reservoir (8).
2.
When filling the reservoir, make sure the
maximum level shown on the reservoir is not
exceeded.
3.
Re-place the water reservoir in the relevant
22
Proportion
1:0
1:0,5
1:1
1:2
1:3
0:1
housing until it clicks into place.
4.
Repeat the operation every time the water-level
indicator light (14) turns on.
Never add any perfume, vinegar, starch,
scale-removing agents, ironing products or
other chemicals in the water reservoir - unless
recommended by Hotpoint-Ariston. Never use
contaminated water.
USING YOUR IRON
Temperature
selection
(B)
adjustment
1.
Connect the plug of the appliance to a grounded
socket (220/240V).
2.
Turn the ON/OFF knob (15) so that the ON light
will light up to show that the steam generator is
ON.
3.
Wait until the temperature indicator on the iron
light turns off before starting ironing.
4.
Select the appropriate steam setting by means
of the ON/OFF knob (16) in position
with steam or in position
steam. As soon as the selected steam quantity
is available, the Steam Ready indicator light (16)
will turn on.
Fabrics with this symbol on the label
must not be ironed.
GARMENT
FABRIC TYPE
LABEL
synthetic
silk
mixed cotton
wool
mixed wool
cotton
linen
jeans
USING THE APPLIANCE
When you switch on the steam generator
for the first time, you may notice an
unpleasant smell, a little smoke and some
impurities. They will disappear in a few minutes.
and
steam
to iron
to iron without
TEMPERATURE
STEAM
INDICATION
INDICATION
MIN
Min
Min
MAX
Publicité
Table des Matières
