Installing The Bidet Attachment - brondell FreshSpa FSP-150 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRODUCT INSTALLATION

Installing the bidet attachment

1. Remove the existing toilet seat.
a. Lift hinge covers and use flathead or Phillips
head screwdriver to remove the mounting
bolts. Alternatively, you may need to loosen
mounting bolts underneath the seat.
b. Remove the toilet seat and set the seat,
mounting bolts, and hardware aside.
2. Turn off water supply valve and flush toilet.
a. Turn off water supply at the wall to stop flow
of water.
b. Flush toilet and hold down handle to
completely empty toilet tank.
c. Disconnect water supply hose from the fill
valve under the toilet tank.
3. Connect ⅞" T-valve to water supply line and
fill valve under toilet tank.
a. Install the ⅞" T-valve with included rubber
washer to the incoming water connection
on the bottom of your toilet tank. Ensure the
rubber washer is properly seated, tapered
side up.
b. Connect the cold water supply line coming
from the wall to the bottom of the T-valve.
6
Step 1b
Step 2c
Step 3a
Step 3b

Publicité

Table des Matières
loading

Table des Matières