Rev-A-Shelf BDC-200-11 Instructions D'installation page 2

STEP 1
Remove your drawer from the
cabinet and mount rails to the
outside of the drawer box with
provided screws
(See Figure A).
STEP 2
If the cover needs trimming,
determine the needed width
by measuring the distance
outside of the rails and
subtracting 1/4"
(See Figure B).
STEP 3
Transfer the measurements to
the cover. To keep the cover
centered in the drawer, divide
the measurement that needs
to be trimmed off by two and
cut both the left and right side
of the cover (See Figure C).
STEP 4
Cut the cover by scoring the
tray several times with a
utility knife and straight
edge and break off the
unneeded pieces.
STEP 5
Slide cover into the rails and
reinstall the drawer. Installation
is now complete.
(See Figure D).
2
FIG. A
FIG. B
FIG. C
FIG. D
Customer Service: 800-626-1126 | rev-a-shelf.com