Call Up Chaser; Run A Chaser; Switch Off Individual Dmx-Channels; Call Up Several Chasers - EuroLite KRX-16 Mode D'emploi

Push channel-faders to the desired setting.
Press the Program-button in order to memorize the first step.
Repeat the steps mentioned above until you have memorized all steps.
Press the Blackout-button in order to memorize the chaser.

6.7 Call up chaser

Press the Pattern-button where you memorized the desired chaser.
Push the Master-fader to maximum.
The chaser will be called up.

6.8 Run a chaser

Adjust the desired fade-time via the Fade-Fader.
Adjust the desired chaser-speed via the Speed-fader.
If the chaser is to be run sound-controlled, press the Audio-button and adjust the desired sensitivity via the
Audio-fader.
If the chaser is to be run exactly in the bass-beat, pull Speed-fader to minimum and enter the bass-beats by
pressing the Tap Sync-button repeatedly.
If the chaser is to be run step by step, pull Speed-fader to minimum and press the Step-button repeatedly.
If the chaser's steps should glide one into another, you can use the Glide-function. Deactivate chaser first,
then press the Glide-button and activate the chaser.

6.9 Switch off individual DMX-channels

You can switch off an individual channel by pressing the Kill-button and the respective Flash-button.
In order to switch the channel on again, press the Kill-button.

6.10 Call up several chasers

Via the Add-function, you can run several chasers.
Press the Pattern-button of the desired chaser.
Press the Add-button.
Press the Pattern-button of the second chaser.
Please note:
Several chasers of one group can only be run one after the other.
Several chasers of different groups can be run simultaneously.

6.11 Go-function

When the output level of a chaser should not vary as programmed, you can lock it by pressing the Go-
button.
If you press the Go-button for more than one second, the Fade Time adjustment is overrun.

6.12 Set all channels to maximum

Press the Full On-button and all channels will be set to their maximum value. As soon as you release the
button, the channels return to their original setting.

6.13 Blackout-Mode

Press the Blackout-button and all devices will be set to Blackout-mode.
Press the Dark-button and all devices will temporarily be set to Blackout-mode.

6.14 Footswitch

Connect your footswitch via the Remote-socket on the rearpanel. In this way you can select Full On or Stand
By.

6.15 Lock program mode

If you want to protect your programs from undesired acces, you can lock the program mode.
Press and hold the Step-button and Blackout-button.
Press the Program-button in order to select ON.
Release the Program-button.
20/35 70064620X74NXS_V_1_0.DOC