auna Silencium Mode D'emploi page 23

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Note: This device must be used with the AC/DC adaptor supplied in the
package.
Never attempt to recharge conventional dry cells.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
Never use another type of battery or non-rechargeable batteries
to replace the rechargeable (LR03/AAA) batteries supplied. When
the headphones are not in use, switch it OFF to avoid damaging the
batteries.
Prolonged exposure to Excessive sound pressure from earphones and
headphones may cause hearing loss.
TROUBLESHOOTING
No Sound
Distortion
Ensure the AC/DC adaptor is fully inserted
into the AC outlet and the power connection
input on the Transmitter.
Ensure the Power Button at the back of
Transmitter is switched to ON.
Ensure the headphone is switched ON.
Headphone battery charge level may be too
low, recharge the batteries fully.
Ensure the TV or the connected audio device
is switched ON.
The volume of headphone may be too low,
adjust the volume to a moderate level.
The audio signal input level is too low.
Increase the volume of the audio source.
Ensure the volume level of headphone is set
to an approximate level.
The headphone is too far from the
transmitter, move it closer.
The audio signal input level is too low.
Increase the volume of the audio source.
EN
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10034062

Table des Matières