auna Silencium Mode D'emploi page 20

EN
20
LAUNCH AND OPERATION
Transmitter
1. Turn on the audio source (TV or
audio component) to which the
transmitter is connected.
2. Slide the power switch located
on the rear of the Transmitter
to "ON". The Power LED starts
to flash in BLUE for around 8 to
9 seconds and then remains to
glow steadily.
3. Select the appropriate Audio
Input position.
4. Either Optical or Coaxial Audio
Input is selected, the Optical/
Coaxial LED Indicator will light
up in RED in the front of the
transmitter.
Headphone receiver
1. Turn on the headphone by pressing the Power button for about 2
seconds. The LED will light up in RED, and then change to GREEN when
Audio Signal link between Transmitter and Headphone Receiver is
established. If no Audio Signal is detected, this LED will glow in RED
constantly.
red: Operation
green: connection
established