Chapter 2: Using The Remote Control; Button Descriptions For Tv Mode; Button Descriptions For Other Modes - RCA TOCOM 1616362B Guide D'utilisation

Chapter 2: Using the Remote Control

Indicator
ON OFF
VCR1 TV
DVD VCR2 AUX SAT•CABLE
MUTE SKIP
SOUND GO BACK
GUIDE INFO
OK
MENU
CLEAR
1 2 3
4 5 6
7 8 9
WHO•INPUT ANTENNA
0
REVERSE PLAY FORWARD
RECORD STOP PAUSE
8
Graphics contained within this publication are for representation only.

Button Descriptions for TV Mode

Arrows Used to point to different items in the TV menu and to adjust the menu
controls.
Indicator Indicates the programming mode when programming the remote to
control components. Lights when you press a valid button on the remote. Flickers
when a button is pressed and the batteries are low.
(0-9) Number Buttons Enter channel numbers and time settings directly
through the remote control.
To enter a one-digit channel, enter a zero first. To enter a two-digit channel, press
the two digits and expect a few seconds delay. This is in case you want to enter a
third digit.
CH + or CH - Scans up or down through the current channel list. Press once to
change the channel up or down; press and hold to continue changing channels.
CLEAR Removes any menu or display from the screen and returns you to normal
viewing.
GO BACK Returns you to the previous channel.
INFO Brings up channel banner; press again to clear the screen.
MENU Brings up the Main menu.
MUTE Reduces the TV's volume to its minimum level. Press again to restore the
volume.
OK When in the menu system, selects highlighted items.
ON•OFF When in TV mode, turns the TV on and off. If in another mode (VCR,
DVD, SAT•CABLE, etc.), will turn the component on and off.
SKIP Press once before changing channels and the TV will go back to the original
channel after 30 seconds. Press repeatedly to add more time.
SOUND Displays the SOUND menu.
TV Turns on the TV and puts the remote in TV mode. Also displays current status.
VOL – or VOL + Decreases or increases the TV's volume.
WHO•INPUT In TV mode, press to toggle through the available input sources
(VID1/SVID1, VID2/CVID2, FRNT, CVID3 and current channel). In SAT mode, press to
select available channel lists.

Button Descriptions for Other Modes

AUX Puts the remote in AUX mode. Can also be programmed to operate most
brands of an additional remote-controllable component.
ANTENNA In VCR mode, functions as a TV/VCR button. In SAT•CABLE mode,
functions as a TV/receiver button.
DVD Puts the remote in DVD mode and, if auto tuning is enabled, will turn on the
TV and tune to the correct video input channel.
GUIDE If you're operating another component that has an on-screen program
guide, this button accesses the on-screen guide.
Chapter 2