Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adjusting the Height
During use, allow the baby's toes only to touch the base. DO NOT allow the baby to stand flat-footed on the base. As
baby grows and becomes more active, raise the tray to the next level so that baby enjoys the most comfortable fit and
maximum use of the spin, and bounce features. Discontinue use when baby can stand flat-footed at the highest setting.
ALWAYS remove baby from ExerSaucer before adjusting. Unlock the adjustment knob A by turning to the right, then moving
until the desired height is obtained (there are three positions). Turn the adjustment knob to the left to lock in place. Repeat the
adjustment on the other two pylons. Note: Make sure that all three legs are adjusted to the same position.
IMPORTANT: Always make sure the adjustment knobs are locked in position before placing the child in the activity center.
Care and Maintenance
For Plastic Parts:
Wipe surface clean with cloth slightly moistened with mild soap and water. Allow to air dry.
For Seat Pad:
Machine Wash Separately, Cold Water – Delicate Cycle. NO CHLORINE BLEACH.
Tumble Dry: 10 – 15 Minutes on Low Heat – Remove Immediately.
If musical toys fail to operate, check the batteries. Note: ONLY the AAA batteries are replaceable. Dispose of old batteries safely.
DO NOT use this product if any parts are damaged, broken, or missing and call Evenflo ParentLink at 1-800-233-5921
(U.S.A.), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
Battery Information
Battery life varies with use. For best results, use alkaline batteries. Safety Information: Batteries are small objects. Batteries must
be replaced by adults. Follow the polarity (+/-) diagram in the battery compartment.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline and standard (carbon-zinc) batteries. Use only batteries of the same or equivalent type.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• Promptly remove old batteries from the toy.
• Remove batteries before storing unit for a prolonged period of time.
• The supply terminals are not to be short-circuited.
Battery Replacement: To replace batteries, loosen screw and remove battery door. Discard old batteries properly and replace
with 3 AAA alkaline or standard batteries. Replace door and tighten screw.
Troubleshooting:
Toy does not turn on or does not respond.
• Make sure batteries are installed correctly.
• Make sure battery cover is correctly secured.
• Install new batteries.
Toy makes improper responses.
• Check or install new batteries.
UNLOCK
A
WARNING
WARNING
6
ADJUST
LOCK
A
A
Publicité
Table des Matières
