BabyActive Exer Saucer Jam Session Instructions page 5

C
B
C
C
G
E
D
E
F
C
H
5. Insert a foot C into the bottom of each pylon B, as shown.
Secure each foot with one 8-16 X 75 mm screw D and five
8-16 X 18 mm screws E. Tighten all 12 screws securely but
E
do not overtighten. DO NOT USE POWER TOOLS.
IMPORTANT: Each foot MUST sit completely flat in the
bottom of the pylon. If it is raised on either end, then one of
the stabilizer tubes is not installed correctly or is not fully
inserted. If this is the case, remove the stabilizer tube and
reinstall until the foot fits over it correctly.
B
C
F
I
3
Assembling the ExerSaucer
C
D
E
6. Turn the pylon assembly upright, as
shown.
Locate the base F and place it in the
center of the ExerSaucer.
Insert each tab on the base F into
each foot C, as shown.
7. Place seat ring G upside down and
locate the wheel holders H.
Snap four seat wheels I into wheel
holders, as shown.
E
E