Cardin Elettronica S504 ITO Mode D'emploi page 17

SYSTEM MANAGEMENT OPERATIONS
Attention! Before memorising the transmitters for the first time remember to cancel the
entire memory content.
• Memorizing a channel code
1. Press and hold down button "P1", LED "L2" will flash slowly.
2. At the same activate the transmitter channel to be memorised, "L2" will remain lit for 2
seconds indicating that the channel has been memorised; if the LED keeps flashing slowly
the channel was already memorised. Only one channel can be memorised at a time. To
insert another channel repeat points 1 and 2 after having released the button. When the
code memory is complete (1000 transmitters memorised) you may only memorise a new
transmitter after you have completely cancelled an existing transmitter or after cancelling
the entire memory content.
• Deleting a channel code (via an associated transmitter)
1. Press the button "P1" twice and hold down after pressing the second time: LED "L2" will
flash at brief intervals.
2. Activate the transmitter channel to be cancelled, "L2" will remain lit for 2 seconds indicating
that the channel has been cancelled;.
To cancel another channel repeat points 1 and 2 after having released the button.
• Deleting the entire code memory content (users)
- Press "P1" three and hold down after pressing the third time. During the cancellation
procedure (3-4 seconds) LED "L2" remains lit. After cancellation the LED will flash 3 times;
at this point release the button.
17