Preparing The System - Cardin Elettronica S504 ITO Mode D'emploi

Transmitters 433 MHz
TXQ504C2
TXQ504C4
TXQ504C8
TXQPRO504-4
TXQPRO504-4A
Radio programmer 433 MHz
RPQ504IT0
Memory module ZGB24LC64-I/P
The module is furnished with a none-volatile EEPROM type memory and contains the transmitter
codes and allows you to memorise up to 1000 codes. The programmed codes remain stored even
in the absence of power.
Attention! Removing and inserting the memory module must be carried out when the receiver is
switched off otherwise the memory content could become corrupt.

PREPARING THE SYSTEM

To obtain the best results from the radio control system the aerial installation site should be carefully
chosen. 'Range' is intended to mean the working distance, measured in free space, between the
receiver and the transmitter with the aerial installed.
The range is therefore closely linked to the technical characteristics of the system and varies accord-
ing to the characteristics of the site in which the system is located.
For best performance we advise you to use the Cardin ANS400 / ANQ800-1 aerial. Wire the aerial
to the receiver using a coaxial cable RG58 (impedance 50Ω) with a maximum length of 15 m.
Transmitters 868 MHz
TXQ508C2
TXQ508C4
TXQ508C8
TXQPRO508-4
TXQPRO508-4A
Radio programmer 868 MHz
RPQ508IT0
12
Description
2-channel precoded transmitters
4-channel precoded transmitters
8-channel precoded transmitters
4-channel precoded industrial transmitters
4-channel precoded industrial transmitters + aerial
Description
Radio programmer ON/OFF + timer 2000 W