Velleman VPT3/1 Manuel D'utilisation page 2

The forward/reverse button (5) is a three-position switch above the trigger (4). Push the button to the far left or right
to determine the rotation direction of the drill ; in the central position, the drill is locked. The trigger provides variable
speed control: pulling the trigger harder increases the speed.
Keep the forward/reverse button in the central position when the tool is not in use.
4. Jigsaw
1. Jigsaw blade
2. Blade retaining hex screw + clamp
3. Blade safety guard
4. Base plate angle adjustment hex screw
5. Base plate
6. Trigger locking button
7. ON/OFF trigger
8. Hex key
9. Battery connector
Speed (no load): 1700 strokes per minute
Cutting depth: 50mm
! Make sure the trigger is extended all the way (OFF position) and the battery is disconnected before making any
adjustment or repair to the device.
Start by familiarising yourself with the components and setup of the saw. Loosen the blade retaining hex screw (2)
with the supplied hex key (8). Remove the screw and pull off the blade clamp and jigsaw blade to be replaced. Insert
the new jigsaw blade into the clamp and align the blade and clamp holes. Put the jigsaw and clamp onto the motor
arm, the blade teeth facing outwards, making sure the blade, clamp and motor arm holes are aligned. Insert the hex
screw and fasten it.
The base plate (5) of the jigsaw is capable of tilting up to 45°. To adjust the cutting angle, first loosen the base plate
angle adjustment hex screw (4). Tilt the base plate to the desired angle and tighten the hex screw (4).
Before operating the jigsaw, make sure the work piece is clamped securely. To start cutting, pull the trigger (7) ;
press the trigger lock (6) simultaneously if needed. Allow the jigsaw blade to move freely and obtain full speed before
attempting to saw. Make sure the jigsaw blade has come to a full halt before touching it or putting the tool down.
5. Delta Sander
1. Hook & loop sanding sheet
2. Sanding plate
3. ON/OFF trigger
4. Handle
5. Battery connector
Speed: 0-6000 movements/minute
Sanding sheet size: 90mm
! Make sure the trigger is extended all the way (OFF position) and the battery is disconnected before making any
adjustment or repair to the device.
The sanding sheets (1) are attached to the triangular base of the sander (2) by means of a velcro-type adhesive
system. This makes replacing the sanding sheet simple and quick. The sanding sheet (1) must align exactly with the
sanding plate. Once a suitable sanding sheet is in position, the device is ready for use by pulling the trigger (3).
The information in this manual is subject to change without prior notice.
VPT3/1 2 VELLEMAN