Camp Chef FP40 Mode D'emploi page 4

INSTALL CENTER PANEL AS SHOWN USING QTY 2 #10 SCREWS.
DO NOT TIGHTEN THE SCREWS ALL THE WAY AT THIS POINT.
0612-FP40-Instructions.indd 6-7
INSTALL BOTTOM ASSEMBLY AS SHOWN USING QTY 14 #10 SCREWS.
NOTE USE A LONG PHILLIPS SCREWDRIVER TO REACH THROUGH THE ACCESS HOLES IN THE BOTTOM ASSEMBLY.
YOU WILL NEED TO REACH THROUGH THE LARGE HOLES IN THE BOTTOM TO GET THE SCREWS STARTED.
DO NOT TIGHTEN THE SCREWS ALL THE WAY AT THIS POINT.
STARTING WITH THE REAR PANEL MAKE SURE THE OUTSIDE SURFACES
OF THE PANELS ARE FLUSH WITH THE OUTSIDE PANELS OF THE BOTTOM ASSEMBLY AND TIGHTEN THE SCREWS.
ASSEMBLE THE REGULATOR HOSE TO THE MANIFOLD USING THE SUPPLIED WRENCH.
DO A SOAP AND WATER TEST TO CHECK FOR LEAKS AT THIS CONNECTION BEFORE LIGHTING THE FIREPIT.
6/18/12 2:37 PM