Description Of The Device; Installation; Use - Saba CB295WDIX/2 Mode D'emploi

(1) Calculation on the basis of results for 24 hours under standard
test conditions� The actual energy consumption will depend
on use and the location of the device�

Description of the device

12
1
GB
2
3
4
5
1� Refrigerator shelf
2� Vegetable box cover
3� Vegetable box
4� Upper Freezer drawer
5� Bottom Freezer drawer
6� Upper refrigerator door shelf
NOTE: The appliance design is subject to change without prior
notice�
32
6
7
9
8
10
11
7� Water tank
8� Small refrigerator door shelf
9� Water tray
10� Water tray cover
11� Handle
12� Thermostat & light

Installation

Position the appliance and allow it to stand for two to three hours
before it is turned on for the first time to allow the system to
settle� Do not position next to any heat source e�g� cooker, boiler
or in direct sunlight etc�
Allow at least 10 cm of space at the top and 10 cm of space
on both sides of the appliance and between the back of the
appliance and the wall for adequate air circulation� The appliance
is not designed for recessed installation ("building in")�
Install on a good firm level surface, and any unevenness of the
floor should be corrected prior to installation, slight unevenness
can be overcome by adjusting the front feet�
NOTE: If the appliance is positioned on a carpet, soft floor
covering you should readjust the front feet once the appliance
has had time to settle�

Use

• This appliance is designed to operate in ambient temperature
between 18°C and 38°C� If these temperatures are exceeded,
i�e� colder or warmer, the appliance will not operate correctly�
If the ambient temperatures are exceeded for long periods, the
temperature in the freezer section will rise above -18°C and
food spoilage may occur�
• Remove all packaging materials from the appliance� Wash the
inside of the cabinet with lukewarm water and bicarbonate of
GB
33