MPM VIRA MOD-22 Notice D'utilisation page 27

WARNING! Do not ever vacuum wet floors with your vacuum cleaner (in dry cleanning mode)
Using the equipment described above you can clean:
- Floor and carpet head (H1) – used to remove dust from carpets, rugs and hard
floor surfaces. It is equipped with rings allowing easier handling and a button. After
pressing the button you can adjust the head for hoovering hard surfaces, for exam-
ple floors, parquets.
Narrow attachment (H5) – used to clean places that are not easily accessible.
-
- Turbo brush (H6) – for cleaning carpets, fitted carpets.
- integrated brush (H7) - thanks to its position on the suction pipe, it is instantly ac-
cessible and saves time. To use it, remove the current equipment from the end of
the tube and rotate the brush 180° until the lock engages.
CAUTION! To disconnect the suction pipes and equipment, press the pipe lock button (E4) located on the suction
pipe and/or handle.
WET WASHING AND CLEANING
1. Make sure that the device is disconnected from mains.
2. Lift an engine's set above the container. Make sure that a filter (A8) is mounted.
3. Lift water filter element (B2) and container (B1).
4. Remove the water filter tube (B4), as its presence during wet vacuuming can cause foaming.
Put the rubber stoppers (B9) on the tabs with holes, on the lower part of the water body (B2)
fig.18.
5. Pour clean water into the washing liquid container (in order to check its level use the indi-
cator of water level (C4) and shampoo (quantity of a shampoo has been given on a bottle).
ATTENTION! When using a function of surface washing do not put water into the water filter container (B1).
6. Reinstall the container (B1) so that the suction inlet (B8) is on the opposite side to the short
washing hose socket in the washing liquid tank. Then lock the locks (D3), install the body (B2)
in the container (B1). Fit the motor unit and lock the locks (B6).
7. Connect a short washing hose (C2) to washing liquid tank (C1) (PIC. 15) and to the connector
at the back of engine's set (PIC.14).
8. Connect sucking hose (E5) to sucking inlet (B8) and sucking tubes (E9).
9. Connect fixing element (E2) to connector for a washing liquid hose (A3)
10. Connect washing tip (F1) to sucking tubes or directly to the handle. A tip for delicate cleaning
(G1) can be connected only to the handle. To wash carpets, rugs and to wash a floor use a
normal tip. To wash armchairs, sofas, curtains, car upholstery etc. use a tip for delicate wet
cleaning, attaching it directly to the handle.
11. Connect the device to the mains.
12. In order to switch on a pump press a pump switch (A1).
13. Press liquid feeder lever (E6). Water and shampoo (washing liquid) are pumped from a liquid
container with a pump and sprayed on cleaned surface with a tip. The liquid gets into fibres
and dissolve even permanent dirt. Wait at least three minutes to let shampoo to be absorbed.
14. Switch off the pump with a switch (A1).
15. Press a vacuum cleaner switch (A2) in order to start sucking function and move the tip on
the floor surface. When washing upholstery, suction of dirty water and spraying of a liquid
mixture may take place at the same time.
27