Using The Appliance - MPM VIRA MOD-22 Notice D'utilisation

1. Disconnect a short washing hose (C2), located between washing liquid container (C1) and
engine's set and carefully take it from the connector (PIC.1,2).
2. Disengage the clamps (B6) (PIC.3). Lift an engine's set with the use of fixed handle and take
water filter element off (B2).
3. Release locks (D3) from the base and lift water filter container (B1) and washing liquid tank
(C1) (PIC.3).
4. Mount the wheels (D2) on the underside of the base (D1) if they have not been mounted
already.
5. Make sure that a foam filter (A8) is fixed in a float chamber (A7) (PIC.4).
6. Fix a water filter tube (B4) (PIC. 8), through a rubber gasket (B5) (PIC.9).
7. Put washing liquid tank (C1) on a base (D1), fix the water filter container (B1) and block the
locks (D3).
8. Within the head (B2), install the water filter sponges (B3) and 2 pieces of rubber plugs (B9) on
the tabs with holes, on the lower part of the water body (B2) fig.18.
9. Next put the water filter tank (B2) on the water container (B1) (PIC.11).
10. Put engine's set on the container and fix using clamps (B6).
11. To fix the sucking hose (E5), put a fastening element (E1) to sucking inlet (B8).

USING THE APPLIANCE

To ensure the highest comfort and safety a vacuum cleaner has been equipped with a water
filter. It is a specially designed device whose role is to absorb the tiniest particles of dust and
dust mites with the use of physical properties of water. Principle of water filter operation is
that the air sucked into the vacuum cleaner goes through a water container, leaving all dust
and dust mites in it.
DRY CLEANING (WITH WATER FILTER HEAD)
1. Make sure that the device is disconnected from mains.
2. Disengage the clamps (D6) and lift an engine's set using a handle.
3. Take a water filter element (B2) off (PIC.10) and fill it with clean water (max. 2l).
4. Put a water filter element (B2).
5. Put an engine's set back on the device and lock the clamps.
6. Connect a sucking hose (E5) (PIC.5), using a fixing element (E1) to sucking inlet of the vacuum
cleaner (B8).
7. Additional accessories can be connected to sucking tube (E9) or directly to a handle (E8) de-
pending on what you are going to do.
8. Connect the device to the mains.
9. Use a switch (A2) to switch a vacuum cleaner on.
10. If the vacuum cleaner sucks in a substance that will foam the water in the water filter, im-
mediately turn off the vacuum cleaner, unplug the power cord and add 2 or 3 drops of the
defoamer (H4) to the water in the water bin. Resume vacuuming. If foaming persists, change
the water in the water bin.
CAUTION! For a fresh scent in the vacuumed room, sprinkle the HEPA 13 filter with a little air freshener (H2).
WARNING! If liquid container is empty or if you do not use washing or wet cleaning function, do not use the
pomp.
26