Overvoltage Protection - Hama P2223771 Mode D'emploi

5. Connection
Warning
• Only operate the product from an approved socket that is
connected to the public power supply. The socket must be
installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/
Off switch – if this is not available, unplug the power cord
from the socket.
• If using a multi-socket power strip, make sure that the total
power consumption of all connected devices does not exceed
the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged period,
disconnect it from mains power.
All devices must be switched off before devices can be connected.
The overvoltage protector may be connected only between the
electrical consumer and an earthed socket. In the operational state,
the indicator light for the overvoltage protector lights up.
Warning
If the indicator light is not lit after switching on, the overvoltage
protector is defective – it may no longer be used and must be
exchanged for a new overvoltage protector.
6. Care and Maintenance
Note
Disconnect the device from the power supply before cleaning it
or if it is not going to be used for a long period of time.
• Only clean this product with a slightly damp, lint-free cloth and
do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
8. Insurance cover of 500 000 euros
Our product liability insurance provides cover of up to 500 000
euros for personal injury and damage to property. The prerequisites
are proper product use (please note the safety information) and
proof that the damage is attributable to non-compliance with the
described protective function (please see the technical specifications
on the type plate and in these operating instructions).
9. Technical Data
Overvoltage pro-
tection
Total
leakage current
Mains supply
Cable cross-
sectional area
Connected load
Up: L-N=1,5kV; L/N-PE=2,0kV;
Uc: 255V~ 50Hz
Uoc: L-N=3,0kV; L/N-PE=6,0kV
18.000 A (3 x 6000 A)
250 V~ / 50 Hz / 16 A
1,5 mm
2
max. 3680 W
9