Horizon Global 76911 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
1. Install receiver housing to hitch - a) Take the receiver and the weather covers out of case. b) Unlock the blue handle using key attached
and remove the housing from the receiver by pressing the blue handle and rotating clockwise until a click sound, as shown in Figure A, B,
and C. c) Install the top/bottom weather cover to the housing, see Figure D. d) Attach the housing to the hitch using M12 bolt
k
washer , and prevailing torque nut
Tighten the fasteners for housing to 92 Lb-Ft (125 N*M).
m
2. Keep the card in the glove compartment. Peel off the label
and door jamb respectively, see Figure F.
Note: For receiver installation & use, see instruction 76900N with receiver kit.
A
CLICK
2

C
©2021 Horizon Global ™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76911
l
, as shown in Figure E.
B
1
n
and apply them on the top of the receiver
E
✓
1
Proper torque is needed to keep the
hitch secure to the vehicle when towing.
Sheet 3 of 15
D
Representative
Brackets
2
76911N 5-21-21
j
, flat
Rear
3
Rev. B