Jonsered J630ES Manuel Du Propriétaire page 6

ASSEMBLY / PRE-OPERATION
INSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive control rod is installed on the snow thrower.
1. Remove plastic tie securing traction drive control rod
to rotator bracket.
2. With top end of rod positioned under left side of control
panel, push rod down and insert top end of rod into
hole in traction drive control lever. Snap rod into place
by pushing down.
NOTE: Engage lever once and rod should snap into place.
TRACTION DRIVE
TRACTION DRIVE CON TROL LEVER
PLASTIC TIE
CONTROL ROD
FIG. 3
TRACTION DRIVE
CON TROL ROD
FIG. 4
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger control rod is installed on the snow thrower.
1. Remove plastic tie securing auger control rod to lower
handle. (See Fig. 5).
2. Push down on the auger control rod and bring top
end of rod up between the metal console and plastic
console cover at right control lever.
3. With control lever in the raised position, insert end of
control rod in slot of control lever.
NOTE: Engage lever once and rod should snap into place.
AUGER CON TROL LEVER
AUGER
CON TROL
ROD
6
PLASTIC TIE
FIG. 5
FIG. 6
AUGER
CONTROL
ROD