Chariot BABYSITZ Mode D'emploi page 8

2. Double Child Carrier
A. Installing the Front Mounting Parts to your Carrier (one time installation)
Any reference to orientation (left or right) is from the passenger's point of view while in the
carrier.
The arrow indicates the drilled hole location in the carrier's left front frame. See Figure 11
above. Older carriers have a bare through hole, newer carriers have a nut that is permanently
installed with a bolt attached on the inside.
Older carrier - Place the Infant Sling anchor bar inside the child compartment and position
the plastic brackets between the aluminum upper frame and the fabric body from the front or
top depending upon your carrier. Almost all components in the hardware kit will be used.
Place the metal washer on the longer (1 5/8") bolt and insert the bolt through the plastic
brackets and through the upper frame from the outside of the carrier towards the inside.
Place the nylon washer on the bolt then the nut and tighten the nut and bolt with a Philips
screwdriver and a 7/16" or 11mm wrench. Tighten the nut and bolt until the end of the bolt
is flush with the nut. See Figure 12a.
Note: Depending on the carrier that you have purchased, it may be easier to insert the bolts if
the carrier is partially folded.
Newer carrier - Using a Philips screwdriver, remove the pre-installed bolt from the nut
secured in the carrier's upper frame. Place the Infant Sling bar inside the child compartment
and position the plastic brackets against upper frame from the inside of the carrier. Place the
metal washer from the hardware kit on the bolt and push the bolt through the plastic bracket
and frame to engage the pre-installed nut. Tighten the bolt until secure. See Figure 12b.
Figure 11
B. Top Attachment
There is a top and bottom orientation to the Infant Sling. Position the Infant Sling in the
carrier so that the grey padded cushion on the end of the sling is at the foot well of the
carrier. For every carrier except the Corsaire and Corsaire XL, fasten the two Infant Sling
straps around the upper seat frame of the carrier. Feeding the strap around the bar from the
bottom, pull the strap up and around the bar and then into the ladder lock and tighten. See
Figures 13a, 13b, 13c.
Figure 12a
Page 8 of 13
Figure 12b