Maruyama MS75 Manuel Du Propriétaire Et De L'utilisateur page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5
Engine will start.
After pulling starting rope gently by two or
three times, pull it hard to start the engine.
[Pulling method for starting rope]
1. Grasp starting rope tight with right hand.
2. Hold chemical tank with left hand.
3. Pull starting rope slowly until resistance is felt.
4. Pull starting rope straight from entrance of
starter.
5. Do not pull starting rope to the end.
6. Don't release starting rope from pulled state,
and let it return to its original state gradually.
CAUTION
If the engine does not start by repeated action,
try pulling the rope after fully opening the choke.
※ If the engine still does not start, refer to
page 23.
Recoil Starter
6
CAUTION
・Frequent operation of choke when starting the
engine causes too much fuel to be sucked in,
making the engine difficult to start. In that
case, start after making the choke fully open.
・After starting the engine, accelerate bit by bit
quickly by opening and closing the throttle
lever several times.
・This operation is to bleed air in the carburetor.
When there is air present, there is the possi-
Starter rope
bility of poor acceleration and engine stalling.
・Supply fuel prior to use if possible. This will
make starting next time easy.
18
Return choke slowly.
Open
English

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cer300

Table des Matières