Maintenance; Maintenance Schedule - pullman Ermator A 1000 Manuel D'utilisation

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.

Maintenance

Do a check of the prefilter and the HEPA
filter make sure that they are in correct
position.
Remove and replace the prefilter.
Remove and replace the HEPA filter.
To install the filters
WARNING:
air during filter change. Use personal safety
equipment, refer to
equipment on page 4 .
WARNING:
disconnect the power cord from the wall
outlet.
WARNING:
fasteners can cause damage to the
operator.
The HEPA filter and the prefilter must be replaced
when damaged or full. When replaced, use the Toggle
fasteners to close the filter frame to make sure that the
filters stay in correct position.
1. Put the filter frame in position.
2. When the filter frame starts to tighten, the angle of
the Toggle fasteners must be as follows:
1879 - 002 - 11.10.2022
Maintenance
Before each use
Dust can come out in the
Personal protective
Stop the product and
Be careful, the Toggle
Daily
X
a) For A 1000: A>90°.
12 months
X
X
A
5