palintest PAASense Manuel D'utilisation page 5

5
Performing A Test
(Analysis Mode)
When the instrument passes all internal functional
checks on start-up, the screen displays the current
batch code and prompts the user to insert a sensor.
1
Slide the front fastener to the right. Open the instrument
case fully.
2
Rinse out the sample container, then fill the front part
all the way up to the brim with the water sample.
3
Tear open the sensor packet foil along the pre-cut
marks. Hold the sensor through the foil pack, exposing
only the connecting tracks.
4
With your left thumb, press the bottom of the blue
lever. Insert the exposed end of the sensor into the
gap, with the connecting tracks facing up.
Release the lever to secure the sensor in place. Slide
off the foil pouch to expose the sensor.
5
Gently close the instrument lid to immerse the
sensor in the water sample. The test starts
automatically. The display indicates progress of
the test.
Do not disturb the instrument during the test.
Operating the instrument on a vibrating surface may
affect results.
6
The peroxyacetic acid concentration will be displayed.
Press the arrow to scroll through peroxyacetic acid
concentration, temperature, date and time, and
sample number. All results are automatically stored in
the instrument log.
6