Installation
Installing the Plastic Wedges
Plastic wedges supplied with the
product are used to create the distance
for the air circulation between the
product and the rear wall.
To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in
the figure.
3.2. Adjusting the Feet
If the product stands unbalanced after
installation, adjust the feet on the front
by rotating them to the right or left.
3.3. Electrical Connection
WARNING: Do not make
A
connections via extension
cables or multi-plugs.
WARNING: Damaged
power cable must be
B
replaced by the Authorized
Service Agent.
If two coolers are to be
installed side by side, there
C
should be at least 4 cm
distance between them.
Our company shall not be liable
for any damages that will arise
when the product is used without
grounding and electrical connection
in accordance with the national
regulations.
Power cable plug must be within easy
reach after installation.
Connect your refrigerator to a
grounded outlet rated for a voltage
value of 220-240V /50 Hz. Outlet
shall have 10 to 16A fuse.
Do not extension cords or cordless
multiple outlets between your
product and the wall outlet.
10 / 22 EN
Refrigerator/User Manual