Trouble Shooting
ERROR
Display does not power on
Partial display LED
Runs with shocks
E-01
E-013
E-02
E-04
E-05
E-06
E-10
Belt does not run properly
Belt is slipping
POSSIBLE CAUSE
Power plug not connected to the mains
Power switch not in 'ON' position
Socket has no power
Treadmill fuse blown
Faulty MCB
Connections base to upper console
Faulty display
Faulty LED Strip
Faulty LED driver IC
Running belt tension
Running belt alignment
Insuffi cient driver torque
Safety key not positioned
Magnet loose
Poor wiring contact
Cabling connection, short circuit or open circuit Replug all plugs on MCB
MCB error
Stall: impact protection or motor blocked
IGBT (Transistor) damaged or broke
AC voltage too high
Incline motor connection error
Incline motor blocked
Incline motor error
Over current protection
Mechanical part blocking
Burned motor
Burned MCB
Internal motor circuit error
Open motor circuit
Abnormal peak current: torque too high
Motor wearing out
Mechanical part blocking
Lubrication
Running belt tension too high
Too much lubrication
Running belt tension too loose
Motor belt too loose
CORRECTION
Plug in power cable
Turn power switch to 'On' position
Check AC (mains)
Replace fuse
Check and or replace MCB
Replug all connections
Replace display
Replug all console connections
Replace Display
Adjust running belt tension
Adjust running belt aligment
djust torque potentiometer
Position safety key to 'On' position
Replace magnet in safety key
Replug all wiring connections between
upper and lower
Replace MCB
Turn motor manually for few rotations,
and check again
Replace IGBT
Check AC (mains) electrical circuit
Replug all incline motor connections
Restart treadmill
Replace incline motor
Check incoming AC voltage
Check all moving parts (rollers,
bearings, belt...)
Replace motor
Replace MCB
Replug all motor connections
Replace motor
Adjust torque potentiometer
Replace motor
Check all moving parts (rollers,
bearings, belt...)
Apply lubrication (silicon spray)
Adjust belt tension
Try to remove overspill using dry towel
Adjust belt tension
Adjust motor belt tension