Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
02 Brush the foam off the surface with a
soft brush or cotton swab. Do not use
a hard tool to scrape the surface.
03 Do not use soap, solvent or spray
cleaner to clean the transducer.
To clean the reservoir and reservoir cover:
01 Use a soft cloth and vinegar if
there are any foam or limes-
cale deposits on the inside.
02 Rinse with clean water.
Never use products containing bleach to
clean the device, but only dishwashing deter-
gent or vinegar!
No mist.
Mist has an unusual smell.
E-IM-Eclipse-Lot001.indd 14
E-IM-Eclipse-Lot001.indd 14
Never immerse the base ( Fig. 1, point
9) in water!
Storage
Store the device in a dry, cool place out of
reach of children after cleaning and drying.
Faults and remedies
In case of malfunction, under normal condi-
tions of use, please refer to the following list:
the diffuser is not plugged in.
The water level in the reser-
voir is too low.
Water leakage from the res-
ervoir.
The temperature of the unit
is too low.
The water has been stand-
ing in the reservoir for too long.
Check that the device is
plugged in and that there is
no mains fault.
Add water to the reservoir.
Check that the reservoir is
in the right position.
Place the unit in a room at
room temperature half an hour
before use.
Clean the reservoir and pour
fresh, distilled or demineral-
ised water into it.
28-07-22 10:55:44
28-07-22 10:55:44
Publicité
Table des Matières
