Maintenance And Storage - Lanaform Eclipse Mode D'emploi

• First, pour the water into the reservoir
before adding the drops of essential oils.
• Lanaform cannot be held liable in the
event of accidental damage resulting
from any use contrary to the instruc-
tions given in these instructions for use.
Maintenance
and storage
When not using the diffuser, empty the wa-
ter from the reservoir. Never empty the water
from the reservoir on the side of the air out-
let. If water enters the air outlet, it will dam-
age the device! ( Fig. 4)
To prevent this from happening:
• Use a container to pour wa-
ter into the reservoir.
• Do not shake the diffuser.
• Do not move the diffuser when
there is water in the reservoir.
In the event of accidental entry of water into
the air outlet ( Fig. 5, point 1), there is a safe-
ty measure to remove the water from the base
of the diffuser:
• Disconnect the power ca-
ble from the diffuser.
• Completely empty the reservoir from
the side opposite the air outlet.
E-IM-Eclipse-Lot001.indd 13 E-IM-Eclipse-Lot001.indd 13
• Bend the diffuser towards one
of the drainage holes ( Fig. 5,
point 2) to empty the water.
• Leave the diffuser in a dry
place for 24 hours.
Always unplug the device with dry hands
before cleaning it!
Maintenance
If the water contains too much calcium and
magnesium, it may deposit a "white powder"
in the device. If this foam is deposited on the
transducer ( Fig. 1, point 7), it will prevent the
device from working properly.
We recommend:
01 Using fresh, distilled or demin-
eralised water for each use.
02 Cleaning the reservoir every 3 days
and cleaning the transducer
every week.
03 Emptying and cleaning the device
(see explanations below), as well
as making sure that all its parts are
completely dry when it is not in use.
To clean the transducer ( Fig. 6):
01 Place 2 to 5 drops of vinegar on its sur-
face and allow to stand for 2 to 5 minutes.
28-07-22 10:55:44 28-07-22 10:55:44