Publicité
Les langues disponibles
Les langues disponibles
6.
Install the glass slats by adding a drop of the
silicone caulk into the middle of the bottom glass
gasket (Fig. 12). Slide the top glass gaskets
(component E) over one end of the glass slat as
shown in figure 13, and at a slight angle, place the
top of the glass slat up into the top beam, sliding
it up enough to allow the bottom of the glass slat
to drop down into the bottom glass gasket. Slide
the top glass gasket up to fit snugly into the top
beam (Fig. 14). It may be helpful to loosen the
screws on the top rail installed in the previous step
to slide the glass slat into place. Just remember
to re tighten these screws to secure the top rail.
Repeat for remaining glass slats. Install pyramid
post top onto each post.
NOTE: A rubber mallet may be needed for
proper fit.
6
Fig. 12
Fig. 13
Fig. 14
Publicité
